In the conventional sense a Belfast sink is a Butler sink, but with a subtle difference.
It includes an overflow that makes it’s way out of the internal sink bowl with a drain in the top. The conventional Butler sink does not have this.
Interestingly, this is due to differing regulations in London and Belfast on water wastage during the late 17th century. I bet you didn’t know that....!!
The Eclectrica Chateaux Kitchen sink retails for a pricey £1,159 ($2,318) but it’s worth it....
Beautiful, rustic, 14 gauge copper is used to furnish both the interior and exterior of the bowl. Wow.
The contemporary, minimalist look doesn’t real allow for pieces like this. I say poppy cock to that. This would be a stunning addition to any kitchen - a genuine centre piece....
Removing old ceramic tiles can be very difficult and often results in damage to the wall.
Where possible, it is always far better to recolour existing tiles (use specialist tile paints), replace damaged tiles or tile over the top of older tiles.
If tiles have to be removed, you will need the following tools:
Safety goggles, dust mask, wide steel masonry chisel, paint scraper, hot air stripper, protective gloves.
You can then follow the procedures set out below:
Read more...
Laying paper faced tiles can be achieved as follows:
1. Lay the sheet of mosaic tiles onto the floor paper side down, then fill the tile fissures with grout.
2. Let the grout dry a little, then using a notched spreader apply ceramic adhesive to the wall.
3. Push the mosaic sheet onto the ceramic adhesive with the paper facing outwards.
4. Wait for 24 hours. This allows the adhesive to harden.
5. Saturate the paper on the sheet using a sponge then slowly peel away.
6. Dry off the mosaic tile sheet using a cloth. Fill gaps between sheets using grout.
7. Wipe away excess grout immediately if using waterproof grout. Normal grout can be left to harden before removing with a cloth or sponge.
How you lay mosaic tiles is a function of what they are held together with.
Mosaic Tiles backed with netting can be applied as follows:
1. Prepare the wall by applying ceramic adhesive using a notched spreader.
2. Push the sheet of tiles onto the adhesive. Netted tiles can be cut into different shapes that fill particular locations.
3. Leave the tiles in place for at least 12 hours before filling fissures with grout.
